Building the MeArm Robotic Arm Version 1 and below
The MeArm is fun to build and easy to control. The most important step is calibrating your servo motors. To do this you will need to set up your control board first. Links are below which will help you to control your robot and calibrate the all important servo motors.
- MeArm Robot for micro:bit kit
- MeArm Robot for Raspberry Pi
- MeArm Robot Arduino Compatible kit
- MeArm Robot Classic Maker Kit - this kit requires you to provide your own controller. See our main category for examples. Follow the pdf and video guides below for the physical build instructions.
The MeArm Maker requires a separate control board, such as an Ardunio or Raspberry Pi, that can provide a PWM Signal to control the servos
Power at 5-6V and around 2-3A needs to be supplied to the servo motors via the 5+ (red) pin. With Ground from the power supply attached to GND. The remaining pins control the servo motors and require a PWN output from a microcontroller. The PWN signal generator needs to be connected to the GND of the power supply to provide the correct reference voltage.